Most garage door Utah remotes are quite simple and similar to program. We have collected the instructions that will work for most remotes. But, if you have a remote that does not respond the instructions, refer to the owner’s manual.
First, be sure that every opener is together. You will want to program them all at the same time. You will also want to be sure that they all have a fresh pair of batteries in them.
Next, you will need to locate the load and learn button on the motor. Hold this button down for 15 seconds. This should work to erase any old information that was stored on the remotes before. This also works for remotes that have been installed into automobiles.
After you have erased the existing program, you will need to reprogram the remotes. You will do this one by one with each remote. You will push on the load and learn button again, but not for 15 seconds, just push and release. Then, with the remote in your other hand, you will push on the open button until, the light bulb in the remote or motor flashes.
You will do this with each remote separately. Car remotes may work a bit different and you may want to read through the instructor manual before trying to reprogram them.